Differences between revisions 2 and 5 (spanning 3 versions)
⇤ ← Revision 2 as of 2012-10-22 22:23:30 →
Size: 151
Editor: JamesonrollinsATligoDOTorg
Comment:
← Revision 5 as of 2012-10-23 00:05:36 → ⇥
Size: 735
Editor: JamesonrollinsATligoDOTorg
Comment:
Deletions are marked like this. Additions are marked like this.
Line 3: Line 3:
 * Turn OFF PZT high voltage
Line 7: Line 8:
 * Turn PZT high voltage ON
Line 8: Line 10:
 * Make sure beams are centered on
 * Center beam on BS
   * use alignment target on BS
 * Align Y arm PLUS PR2/3:
   * put alignment targets on ITMY/ETMY cages
   * use alignment ruler for PR2/3
   * using PZT1/2, iteratively:
     * center beam on ITMY
     * center beam on ETMY
     * center beam on PR2/3
   * get flashes in Y trans
 * Align PRC:
   * check beam height (center) on PRM/2/3
   * center beam on PRM
 * Align X arm:
   * use BS to center beam on ETMX

 * Center beams on:
Line 11: Line 30:
 * Make sure REFL is clear
 * Make sure AS is clear

 * Turn PZT high voltage OFF

Vent checklists

  • Turn OFF PZT high voltage

Closeup checklist

  • Turn PZT high voltage ON
  • Put input PZTs in center of range.
  • Center beam on BS
    • use alignment target on BS
  • Align Y arm PLUS PR2/3:
    • put alignment targets on ITMY/ETMY cages
    • use alignment ruler for PR2/3
    • using PZT1/2, iteratively:
      • center beam on ITMY
      • center beam on ETMY
      • center beam on PR2/3
    • get flashes in Y trans
  • Align PRC:
    • check beam height (center) on PRM/2/3
    • center beam on PRM
  • Align X arm:
    • use BS to center beam on ETMX
  • Center beams on:
    • IPPOS
    • IPANG
  • Make sure REFL is clear
  • Make sure AS is clear
  • Turn PZT high voltage OFF

vent/checklist (last edited 2018-11-20 06:17:08 by GautamvenugopalanATligoDOTorg)