Attachment 'gpib.conf'

Download

/***********************************************************************
                 GPIB.CONF IEEE488 library config file
                             -------------------

   copyright            : (C) 2002 by Frank Mori Hess
                          (C) 1994 by C.Schroeter
   email                : fmhess@users.sourceforge.net
 ***************************************************************************/
/***************************************************************************
 *    
 *   Syntax:
 *
 *         interface { ... } starts new interface board section
 *         device {...} device configuration
 *
 ***************************************************************************/

/* This section configures the configurable driver characteristics
 * for an interface board, such as board address, and interrupt level.
 * minor = 0 configures /dev/gpib0, minor = 1 configures /dev/gpib1, etc.
 */

interface {
        minor = 0       /* board index, minor = 0 uses /dev/gpib0, minor = 1 uses /dev/gpib1, etc. */
        board_type = "agilent_82357a"   /* type of interface board being used */
        name = "agilent_82357a" /* optional name, allows you to get a board descriptor using ibfind() */
        pad = 0 /* primary address of interface             */
        sad = 0 /* secondary address of interface           */
        timeout = T3s   /* timeout for commands */

        eos = 0x0a      /* EOS Byte, 0xa is newline and 0xd is carriage return */
        set-reos = yes  /* Terminate read if EOS */
        set-bin = no    /* Compare EOS 8-bit */
        set-xeos = no   /* Assert EOI whenever EOS byte is sent */
        set-eot = yes   /* Assert EOI with last byte on writes */

/* settings for boards that lack plug-n-play capability */
        base = 0        /* Base io ADDRESS                  */
        irq  = 0        /* Interrupt request level */
        dma  = 0        /* DMA channel (zero disables)      */

/* pci_bus and pci_slot can be used to distinguish two pci boards supported by the same driver */
/*      pci_bus = 0 */
/*      pci_slot = 7 */

        master = yes    /* interface board is system controller */
}

/* Now the device sections define the device characteristics for each device.
 * These are only used if you want to open the device using ibfind() (instead
 * of ibdev() )
 */

device {
        minor = 0       /* minor number for interface board this device is connected to */
        name = "ag4395a"        /* device mnemonic */
        pad = 17        /* The Primary Address */
        sad = 0 /* Secondary Address */

        eos = 0xa       /* EOS Byte */
        set-reos = no /* Terminate read if EOS */
        set-bin = no /* Compare EOS 8-bit */
}

Attached Files

To refer to attachments on a page, use attachment:filename, as shown below in the list of files. Do NOT use the URL of the [get] link, since this is subject to change and can break easily.
  • [get | view] (2009-02-23 06:11:59, 2426.9 KB) [[attachment:4395A-GPIB-Manual.pdf]]
  • [get | view] (2009-02-23 06:09:59, 2.0 KB) [[attachment:getgpibdata.py]]
  • [get | view] (2009-02-23 06:08:44, 2.4 KB) [[attachment:gpib.conf]]
  • [get | view] (2009-02-23 06:09:22, 0.7 KB) [[attachment:initGPIB]]
 All files | Selected Files: delete move to page copy to page

You are not allowed to attach a file to this page.