|
⇤ ← Revision 1 as of 2006-09-07 20:08:48
Size: 1752
Comment:
|
Size: 13
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 1: | Line 1: |
| - Drawing of the DC readout rack [Rich & Ben] | |
| Line 3: | Line 2: |
| - any updates to Rob's block diagram? http://www.ligo.caltech.edu/~cit40m/Docs/DCdetect/DCdetectWiring.pdf - updates to the wiring diagram D060096 3/30/06 [Rich & Ben] http://www.ligo.caltech.edu/~cit40m/Docs/DCdetect/D060096-00-40M_DC_Detection_Wiring.pdf - add wiring for control of Go's pickoff picomotor - drawings for each component board [Rich & Ben] - Procurement of rack-mounted PC with PCIX bus [Rolf] - PCIX ADC card(s) - PCIX DAC card(s) - reflective memory card - Control software [Rolf and Alex] - PCI66-16AI16 AA Board (32 KHz) [Jay] - in assembly - PCI66-16AO16 DAC Interface board (32KHz) [Jay] - in assembly - Tip Tilt PZT Mirror Driver [Rich] - under design - OMC PZT Driver [Rich] - under design - QPD Whitening board [Ben] - in assembly - PD Satellite box [Ben] - in hand, tested - In Vac DC PD Amp [Ben] - in hand, tested - Two oplev QPDs [Jay] - in hand - Fast trigger to trip off TT PZT mirror - how will we implement this? - HV for TT PZT and OMC PZT - there's at least one sitting on the shelf in lab - DC power supplies - rack (is the little rack near the output optic chamber, currently housing unused EOS electronics, useable? Steve has arranged for conditioned power to it). - cables - anything else? ------ IF the new PZT drivers are not in hand at the time of commissioning, we also need: - OMC length PZT driver (in hand) - TT PZT drivers (in hand) IF the PCIX-based controls not ready yet: - Generic Pentek Interface Board and associated acquisition software / database for DCPD and OMC control signals - Analog servo electronics (in hand and in use) |
Anything? |
Anything?