|
Size: 650
Comment:
|
Size: 786
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 1: | Line 1: |
| Line 9: | Line 8: |
| * Make a long LEMO-LEMO cable to go from the OMC crate to the LSC rack for freq. noise coupling measurements. Get TNC connectors. |
- commission input PZT alignment servo using OMC_T in a bright mich to reduce noise in 1-2KHz
- Along those lines, the REFL beam is clearly clipped in the alignment state which the alignment
- scripts leave us in. Investigate--the best way forward is probably to revisit the PSL periscope/mode cleaner alignment and the Faraday isolator.
- The Pentek at ETMY may be glitchy. The coil driver noise is higher there than any of the other
- test masses. It may be the coil driver itself, but suspicion falls on the Pentek.
- Figure out to get a handle on the oscillator AM measurement, without hacking up the board, if possible.
- Make a long LEMO-LEMO cable to go from the OMC crate to the LSC rack for freq. noise coupling measurements.
- Get TNC connectors.