Diff for "Rob's_To_Do_List"

Differences between revisions 2 and 3

commission input PZT alignment servo using OMC_T in a bright mich to reduce noise in 1-2KHz
Along those lines, the REFL beam is clearly clipped in the alignment state which the alignment
- scripts leave us in. Investigate--the best way forward is probably to revisit the PSL periscope/mode cleaner alignment and the Faraday isolator.
The Pentek at ETMY may be glitchy. The coil driver noise is higher there than any of the other
- test masses. It may be the coil driver itself, but suspicion falls on the Pentek.
Figure out to get a handle on the oscillator AM measurement, without hacking up the board, if possible.

-  ⇤ ← Revision 2 as of 2007-05-10 16:40:15 → 
  Size: 191
  Editor: RobertWard
  Comment:
+   ← Revision 3 as of 2007-05-22 05:39:24 → ⇥
  Size: 650
  Editor: RobertWard
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 1:
-For Fri, May 11th
 * Make LEMO cable for ISS
-Line 4:
+Line 3:
-For Thurs, May 10th
 * solder solder solder
+ * Along those lines, the REFL beam is clearly clipped in the alignment state which the alignment
   scripts leave us in.  Investigate--the best way forward is probably to revisit the 
   PSL periscope/mode cleaner alignment and the Faraday isolator.
 * The Pentek at ETMY may be glitchy.  The coil driver noise is higher there than any of the other
   test masses.  It may be the coil driver itself, but suspicion falls on the Pentek.
 * Figure out to get a handle on the oscillator AM measurement, without hacking up the board, if possible.