PRMI Noise budget

Measurements

• 7/Mar/2012 by KI

Sensor in use

• AS55_Q for MIHC

  • Gain of whitening filter = 30 dB

  • Demodulation phase = 17.6 deg

  
  

• REFL33_I for PRCL

  • Gain of whitening filter = 42 dB

  • Demodulation phase = -38.050 deg

• LO = 11065910 Hz by a Marconi

DC light

• port name	DC power [mW]
  AS (before the attenuation)	0.02 mW
  AS55	? mW
  REFL (before the attenuation)	644 mW
  REFL11	? mW
  REFL33	? mW
  REFL55	? mW
  REFL165	? mW

Sidebands

• The values noted here were estimated from the OSAs at the AS and REFL ports.

Optical gains

• Parameters
  description	values	notes
  Estimated Optical gain	80 uW/m
  Measured pk-pk Michelson error signal	1000 counts	Michelson was freely swinging
  Raw optical gain	5.9052 x10^9 [counts/meter]	= 4 * pi / lambda * (pk value of the error signal)
  Conversion loss of mixer	6.5 dB	from the spec sheet of JMS-1H
  ADC conversion	1638.4 counts / V	16 bit, +/-20 V
  Trans impedance at 55 MHz	556.3 Ohm	AS55 characterization
  Responsibity of diodes	0.8 [A/W]	from the spec sheet of CS3102
  Attenuation in the AS path

Servo filters

• 

• UGF = 55 Hz
• Only FM5 (10:1000) was activated.
• G = -2
• No limiter in the digital path.
• Feeding the signal back to BS.
• Dewhitening filters in BS are ON.
• Assumption : BS actuator has a pole at 1 Hz with Q = 5
• Time delay = (without considering the effects from the analog circuits and the down sampleing filters.)

•      ITMX  = 4.913e-09 / f2   [m/counts]
       ITMY  = 4.832e-09 / f2   [m/counts]
       PRM   = 2.022e-08 / f2  [m/counts]

RAM effects

• Is something going on ?