Diff for "Electronics/POX11"

Differences between revisions 14 and 26 (spanning 12 versions)

The data for the following measurements is located at [https://nodus.ligo.caltech.edu:30889/svn/trunk/docs/upgrade08/RFsystem/RFphotodiodes/POX/ /svn/trunk/docs/upgrade08/RFsystem/RFphotodiodes/POX/]

[attachment:POX_modified_schematic.png Schematic]

RF Transimpedance

attachment:transimpedance.png

The above fit was done in LISO in root mode. The results of the fit are the following:

factor = (-2.1 +- 0.2) Ohms

delay = (9.57 +- 0.02) ns

five poles:

frequency (MHz)	Q
11.133 +- 0.003	14.3 +- 0.1
11.45 +- 0.06	0.595 +- 0.005
25.46 +- 0.02	5.89 +- 0.07
224.33 +-0.02	124 +- 4
100.7 +- 0.9	706.82 +- 0.04

four zeros:

frequency (MHz)	Q
22.67 +- 0.01	35 +- 1
55.4 +- 0.3	(10.0 +- 0.2) x 10⁶
0.93 +- 0.04	3.9 +- 0.6
143 +- 3	631.94 +- 0.04

chi^2/ndf = 432

Alberto's LISO Model

attachment:pox_tf.pdf

Fits To Resonance

More detailed transfer functions were measured around the resonance peaks at 11, 22, and 55 MHz. These transfer functions were fit to attachment:resfitfunc.png where f₀ is the resonant frequency and Gamma is the line width. Q is calculated by f₀/Gamma.

11 MHz Resonance

attachment:res1.png

f₀ = (11.14 +- 0.01) MHz

Gamma = (764 +- 1) kHz

R₀ = (8.38 +- 0.01) x 10⁸ Hz Ohms

C = (11.14 +- 0.05) Ohms

chi^2/ndf = 95.4

22 MHz Resonance

attachment:res2.png

f₀ = (22.68 +- 0.01) MHz

Gamma = (820 +- 1) kHz

R₀ = (-5.64 +- 0.01) x 10⁶ Hz Ohms

C = (23.44 +- 0.01) Ohms

chi^2/ndf = 12.7

55 MHz Resonance

attachment:res3.png

f₀ = (55.29 +- 0.01) MHz

Gamma = (1.74 +- 0.01) MHz

R₀ = (-9.98 +- 0.01) x 10⁵ Hz Ohms

C = (1.62 +- 0.01) Ohms

chi^2/ndf = 3.22

Noise

attachment:noise.png

The noise data was fit to attachment:fitfunc.png with the following results:

Z_RF = (2.07 +- 0.01) kOhms

I_d = (247 +- 6) uA

chi² / ndf = 42

Note that this value for the transimpedance agrees with the above transfer functions since the noise was measured at 11 MHz instead of the resonance frequency of 11.14 MHz.

Alberto's LISO Model

attachment:pox_noise.pdf

RF Behavior with No Light

attachment:timeseries.png

attachment:dark_spectrum.png

Picture of Photodiode

attachment:POX.jpg

Picture taken on 12/13/2010.

-  ⇤ ← Revision 14 as of 2011-01-19 11:40:18 → 
  Size: 1701
  Editor: JenneDriggers
  Comment:
+   ← Revision 26 as of 2011-06-03 01:54:22 → ⇥
  Size: 2594
  Editor: RanaAdhikari
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 1:
-= POX =
+## page was renamed from Electronics/POX
The data for the following measurements is located at [https://nodus.ligo.caltech.edu:30889/svn/trunk/docs/upgrade08/RFsystem/RFphotodiodes/POX/ /svn/trunk/docs/upgrade08/RFsystem/RFphotodiodes/POX/]
-Line 3:
+Line 4:
-The data for the following measurements is located at [https://nodus.ligo.caltech.edu:30889/svn/trunk/docs/upgrade08/RFsystem/RFphotodiodes/POX/ /svn/trunk/docs/upgrade08/RFsystem/RFphotodiodes/POX/]
+[attachment:POX_modified_schematic.png Schematic]
-Line 9:
+Line 10:
-The resonance peaks at 11, 22, and 55 MHz were measured in detail and fit to a resonance curve (see below) with the following results
+The above fit was done in LISO in root mode. The results of the fit are the following:
-Line 11:
+Line 12:
-|| Resonance Frequency || Transimpedance at Resonance || Q ||
|| (11.14 +- 0.01) MHz || (2.206 +- 0.001) kOhms || 14.58 +- 0.01 ||
|| (22.68 +- 0.01) MHz || (9.681 +- 0.003) Ohms || 27.66 +- 0.01 ||
|| (55.29 +- 0.01) MHz || (475 +- 2) mOhms || 31.81 +- 0.05 ||
+factor = (-2.1 +- 0.2) Ohms

delay = (9.57 +- 0.02) ns

five poles:
|| frequency (MHz) || Q ||
|| 11.133 +- 0.003 || 14.3 +- 0.1 ||
|| 11.45 +- 0.06 || 0.595 +- 0.005 ||
|| 25.46 +- 0.02 || 5.89 +- 0.07 ||
|| 224.33 +-0.02 || 124 +- 4 ||
|| 100.7 +- 0.9 || 706.82 +- 0.04 ||

four zeros:
|| frequency (MHz) || Q ||
|| 22.67 +- 0.01 || 35 +- 1 ||
|| 55.4 +- 0.3 || (10.0 +- 0.2) x 10^6^ ||
|| 0.93 +- 0.04 || 3.9 +- 0.6 ||
|| 143 +- 3 || 631.94 +- 0.04 ||

chi^2/ndf = 432

=== Alberto's LISO Model ===

attachment:pox_tf.pdf
-Line 17:
+Line 38:
+More detailed transfer functions were measured around the resonance peaks at 11, 22, and 55 MHz. These transfer functions were fit to attachment:resfitfunc.png where ''f'',,0,, is the resonant frequency and ''Gamma'' is the line width. ''Q'' is calculated by ''f'',,0,,/''Gamma''.
-Line 22:
+Line 45:
-f,,0,, = (11.14 +- 0.01) MHz
+''f'',,0,, = (11.14 +- 0.01) MHz
-Line 24:
+Line 47:
-Gamma = (764 +- 1) kHz
+''Gamma'' = (764 +- 1) kHz
-Line 26:
+Line 49:
-R,,0,, = (8.38 +- 0.01) x 10^8^ Hz Ohms
+''R'',,0,, = (8.38 +- 0.01) x 10^8^ Hz Ohms
-Line 28:
+Line 51:
-C = (11.14 +- 0.05) Ohms
+''C'' = (11.14 +- 0.05) Ohms
-Line 36:
+Line 59:
-f,,0,, = (22.68 +- 0.01) MHz
+''f'',,0,, = (22.68 +- 0.01) MHz
-Line 38:
+Line 61:
-Gamma = (820 +- 1) kHz
+''Gamma'' = (820 +- 1) kHz
-Line 40:
+Line 63:
-R,,0,, = (-5.64 +- 0.01) x 10^6^ Hz Ohms
+''R'',,0,, = (-5.64 +- 0.01) x 10^6^ Hz Ohms
-Line 42:
+Line 65:
-C = (23.44 +- 0.01) Ohms
+''C'' = (23.44 +- 0.01) Ohms
-Line 50:
+Line 73:
-f,,0,, = (55.29 +- 0.01) MHz
+''f'',,0,, = (55.29 +- 0.01) MHz
-Line 52:
+Line 75:
-Gamma = (1.74 +- 0.01) MHz
+''Gamma'' = (1.74 +- 0.01) MHz
-Line 54:
+Line 77:
-R,,0,, = (-9.98 +- 0.01) x 10^5^ Hz Ohms
+''R'',,0,, = (-9.98 +- 0.01) x 10^5^ Hz Ohms
-Line 56:
+Line 79:
-C = (1.62 +- 0.01) Ohms
+''C'' = (1.62 +- 0.01) Ohms
-Line 66:
+Line 89:
-Z,,RF,, = (2.07 +- 0.01) kOhms
+''Z'',,RF,, = (2.07 +- 0.01) kOhms
-Line 68:
+Line 91:
-I,,d,, = (24.7 +- 0.6) mA
+''I'',,d,, = (247 +- 6) uA
-Line 71:
+Line 94:
+Note that this value for the transimpedance agrees with the above transfer functions since the noise was measured at 11 MHz instead of the resonance frequency of 11.14 MHz.

=== Alberto's LISO Model ===

attachment:pox_noise.pdf