Differences between revisions 10 and 27 (spanning 17 versions)
⇤ ← Revision 10 as of 2011-01-19 10:48:58 →
Size: 884
Editor: JenneDriggers
Comment:
← Revision 27 as of 2012-01-03 23:03:06 → ⇥
Size: 2646
Editor: localhost
Comment: converted to 1.6 markup
Deletions are marked like this. Additions are marked like this.
Line 1: Line 1:
= POX = ## page was renamed from Electronics/POX
The data for the following measurements is located at [[https://nodus.ligo.caltech.edu:30889/svn/trunk/docs/upgrade08/RFsystem/RFphotodiodes/POX/|/svn/trunk/docs/upgrade08/RFsystem/RFphotodiodes/POX/]]
Line 3: Line 4:
The data for the following measurements is located at [https://nodus.ligo.caltech.edu:30889/svn/trunk/docs/upgrade08/RFsystem/RFphotodiodes/POX/ /svn/trunk/docs/upgrade08/RFsystem/RFphotodiodes/POX/] [[attachment:POX_modified_schematic.png|Schematic]]
Line 7: Line 8:
attachment:transimpedance.png {{attachment:transimpedance.png}}
Line 9: Line 10:
Transimpedance at 11 MHz: 6.3 kOhms. The above fit was done in LISO in root mode. The results of the fit are the following:

factor = (-2.1 +- 0.2) Ohms

delay = (9.57 +- 0.02) ns

five poles:
|| frequency (MHz) || Q ||
|| 11.133 +- 0.003 || 14.3 +- 0.1 ||
|| 11.45 +- 0.06 || 0.595 +- 0.005 ||
|| 25.46 +- 0.02 || 5.89 +- 0.07 ||
|| 224.33 +-0.02 || 124 +- 4 ||
|| 100.7 +- 0.9 || 706.82 +- 0.04 ||

four zeros:
|| frequency (MHz) || Q ||
|| 22.67 +- 0.01 || 35 +- 1 ||
|| 55.4 +- 0.3 || (10.0 +- 0.2) x 10^6^ ||
|| 0.93 +- 0.04 || 3.9 +- 0.6 ||
|| 143 +- 3 || 631.94 +- 0.04 ||

chi^2/ndf = 432

=== Alberto's LISO Model ===

[[attachment:pox_tf.pdf]]
Line 13: Line 39:
More detailed transfer functions were measured around the resonance peaks at 11, 22, and 55 MHz. These transfer functions were fit to {{attachment:resfitfunc.png}} where ''f'',,0,, is the resonant frequency and ''Gamma'' is the line width. ''Q'' is calculated by ''f'',,0,,/''Gamma''.
Line 15: Line 43:
attachment:res1.png {{attachment:res1.png}}

''f'',,0,, = (11.14 +- 0.01) MHz

''Gamma'' = (764 +- 1) kHz

''R'',,0,, = (8.38 +- 0.01) x 10^8^ Hz Ohms

''C'' = (11.14 +- 0.05) Ohms

chi^2/ndf = 95.4
Line 19: Line 57:
attachment:res2.png {{attachment:res2.png}}

''f'',,0,, = (22.68 +- 0.01) MHz

''Gamma'' = (820 +- 1) kHz

''R'',,0,, = (-5.64 +- 0.01) x 10^6^ Hz Ohms

''C'' = (23.44 +- 0.01) Ohms

chi^2/ndf = 12.7
Line 23: Line 71:
attachment:res3.png {{attachment:res3.png}}

''f'',,0,, = (55.29 +- 0.01) MHz

''Gamma'' = (1.74 +- 0.01) MHz

''R'',,0,, = (-9.98 +- 0.01) x 10^5^ Hz Ohms

''C'' = (1.62 +- 0.01) Ohms

chi^2/ndf = 3.22
Line 27: Line 85:
attachment:noise.png {{attachment:noise.png}}
Line 29: Line 87:
The noise data was fit to attachment:fitfunc.png with the following results: The noise data was fit to {{attachment:fitfunc.png}} with the following results:
Line 31: Line 89:
Z,,RF,, = (2.07 +- 0.01) kOhms ''Z'',,RF,, = (2.07 +- 0.01) kOhms
Line 33: Line 91:
I,,d,, = (24.7 +- 0.6) mA ''I'',,d,, = (247 +- 6) uA
Line 37: Line 95:
Note that this value for the transimpedance agrees with the above transfer functions since the noise was measured at 11 MHz instead of the resonance frequency of 11.14 MHz.

=== Alberto's LISO Model ===

[[attachment:pox_noise.pdf]]
Line 39: Line 103:
attachment:timeseries.png {{attachment:timeseries.png}}
Line 41: Line 105:
attachment:dark_spectrum.png {{attachment:dark_spectrum.png}}
Line 45: Line 109:
attachment:POX.jpg {{attachment:POX.jpg}}

The data for the following measurements is located at /svn/trunk/docs/upgrade08/RFsystem/RFphotodiodes/POX/

Schematic

RF Transimpedance

transimpedance.png

The above fit was done in LISO in root mode. The results of the fit are the following:

factor = (-2.1 +- 0.2) Ohms

delay = (9.57 +- 0.02) ns

five poles:

frequency (MHz)

Q

11.133 +- 0.003

14.3 +- 0.1

11.45 +- 0.06

0.595 +- 0.005

25.46 +- 0.02

5.89 +- 0.07

224.33 +-0.02

124 +- 4

100.7 +- 0.9

706.82 +- 0.04

four zeros:

frequency (MHz)

Q

22.67 +- 0.01

35 +- 1

55.4 +- 0.3

(10.0 +- 0.2) x 106

0.93 +- 0.04

3.9 +- 0.6

143 +- 3

631.94 +- 0.04

chi^2/ndf = 432

Alberto's LISO Model

pox_tf.pdf

Fits To Resonance

More detailed transfer functions were measured around the resonance peaks at 11, 22, and 55 MHz. These transfer functions were fit to resfitfunc.png where f0 is the resonant frequency and Gamma is the line width. Q is calculated by f0/Gamma.

11 MHz Resonance

res1.png

f0 = (11.14 +- 0.01) MHz

Gamma = (764 +- 1) kHz

R0 = (8.38 +- 0.01) x 108 Hz Ohms

C = (11.14 +- 0.05) Ohms

chi^2/ndf = 95.4

22 MHz Resonance

res2.png

f0 = (22.68 +- 0.01) MHz

Gamma = (820 +- 1) kHz

R0 = (-5.64 +- 0.01) x 106 Hz Ohms

C = (23.44 +- 0.01) Ohms

chi^2/ndf = 12.7

55 MHz Resonance

res3.png

f0 = (55.29 +- 0.01) MHz

Gamma = (1.74 +- 0.01) MHz

R0 = (-9.98 +- 0.01) x 105 Hz Ohms

C = (1.62 +- 0.01) Ohms

chi^2/ndf = 3.22

Noise

noise.png

The noise data was fit to fitfunc.png with the following results:

ZRF = (2.07 +- 0.01) kOhms

Id = (247 +- 6) uA

chi2 / ndf = 42

Note that this value for the transimpedance agrees with the above transfer functions since the noise was measured at 11 MHz instead of the resonance frequency of 11.14 MHz.

Alberto's LISO Model

pox_noise.pdf

RF Behavior with No Light

timeseries.png

dark_spectrum.png

Picture of Photodiode

POX.jpg

Picture taken on 12/13/2010.

Electronics/POX11 (last edited 2012-01-03 23:03:06 by localhost)